FPS-300, Fox FPS-300 PLC controlled Pre-Stretch wrapper

$9,368.75
Turntable Speed 0-15 RPM
Base Plate Thickness 5/16 in
Variable Speed Drive 1/2 HP SCR
Power Requirement 115 VAC at 15 Amps, 60 Hz
Diameter1 56 in
Length 50 in
Width 50 in
Height 90 in
Weight 5000 lb
Finish Powder Coat
Features Control Features
  • Programmable Key Pad Controls
  • LCD Display Screen (providing function control viewing)
  • Variable Turntable Speed 0-15 RPM
  • Variable Film Carriage Speed Up/Down Control
  • Seperate Top/Bottom Wrap Selectors 1-9
  • Seperate Film Height Selector 1-9"
  • Plush Mounted Control Panel (built into tower)
  • Cycle Counter
  • Manual Carriage Raise/Lower Control
  • Turntable Jog with Auto Home Alignment
  • Large Emergemy push button power On/Off Switch with indicator light
  • Start Cycle Push Button
  • Standard Wrap Up/Down Program
  • 12 Volt DC Control System (for operator safety)
  • All circuits protected by fuses (easy access)
  • 20 amp Power Board Circuits to carry a 10 amp load
Turntable Drive
  • Positive home alignment and counter
  • 0- 15 RPM turntable speed
  • 1/2 HP SCR variable speed drive
  • Adjustable electronic soft Start/Stop
Structural Features
  • Heavy Duty 3/8" turntable plate
  • Fork Lift portable from rear
  • Formed Steel Tower
  • 5/16" thick base plate
  • Three 3/8" thick support rings
Carriage Lift
  • Ultra Wear slide supports
  • Heavy duty ANSI #50 Chain Carriage Lift
  • 1/2 HP DC SCR variable speed drive
  • Carriage Chain fully guarded
Film Delivery
  • FOX "Linear" 20 inch powered pre-stretch film delivery system
  • Easy thread film carriage
  • No hinges, latches or idler rollers to wear and cause inconsistent film stretching
  • Electronic film force control on film carriage
  • Adjustable mechanical force to load
  • Sensor switch film feed speed control
  • 1/2 HP DC SCR variable speed film drive
  • Pre-stretch 50-300% upon request (200% standard settings)
  • Triple beam auto height eye capable of recognizing all colors including black
Technical Information
  • Rigid base frame construction
  • 32 table support wheels requires no lubrication to the face or under the table (250 lbs dynamic each wheel)
  • Heavy duty #50 chain and sprocket drive system
  • 3" from floor to top of turntable
  • Powder Coat Finish
  • All switches, relays, and SCR controls etc. are available locally throughout North America
  • Complete manual with electrical schematic provided with machine
Options Base and Height Extension
End of Cycle Film Cut-Off
Extended Heavy Duty Ramp for Powered Hand Truck
Loading Ramp
Prices are subject to change